Full Chisel Blog

November 18, 2013

Turned my Peg Board into a finish drying rack

I made this several years ago for clamping odd shaped object using pegs and wedges for tension.  I also have a couple of threaded pegs that allow screw pressure.  I have used it for restoration and repair work as well.  It is 16 1/2″ wide, 36″ long and 1 1/2″ thick yellow poplar with one inch holes spaced over the surface.  I can also use holdfasts in any of the holes.

Recently after finishing with Moses T’s Gunstocker’s Finish some curved stretchers for a table I am working on for a friend, I needed somewhere to place the pieces for the finish to dry with good air circulation.  So I stuck a couple of 1 inch dowels into the holes and they worked to hold the pieces spaced apart.  The weight of the pegboard was sufficient to hold the weight of the stretchers, even set out on the ends of the dowels.

pegboard

An already handy tool has a new ability as a drying rack.

Stephen

No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment

Powered by WordPress